20mm Press Fitting Elbow, Nickel-Plated Pipe Fitting

No, the tube is precisely held in place by a special guide ring before pressing. This prevents slipping out and ensures secure pressing.

Yes, this press-fit angle is designed for aluminum composite pipes of 16 x 2.0 mm. It will therefore fit exactly to your pipe in the bathroom.

Yes, the integrated plastic guide ring ensures precise pipe alignment and secure pressing. This allows reliable installation even in so-called forced positions.

Yes, after cutting the pipe, it is important to calibrate and deburr the ends with a calibrator. This ensures a proper and secure connection.

The angle is designed for both pipe systems: multi-layer composite pipes and DVGW-certified copper pipes. It is a fitting system for both types.

Yes, the press fitting is designed for a durability of 50 years. This applies at a continuous temperature of 70° C and 10 bar.

This angle is permanently loadable up to 70°C and designed for a maximum operating temperature of 95°C. Thus, it can easily withstand 90°C.

No, the angle has a flow-optimized contour with free passage. This ensures the best ZETA values and minimizes pressure losses and flow noise in the system.

Yes, the pressfitting angle prevents the ingress of air oxygen through its void-free compression and two O-rings. This is particularly beneficial for heating systems.

The correct insertion depth of the pipe is visible through the three inspection windows in the stainless steel compression sleeve. Insert the pipe until it stops.

No, the press fitting is not tight until pressed. A secure and tight connection is only achieved through proper pressing.

The press fitting is designed for a maximum operating temperature of 95° C. The long-term durability is 70° C for over 50 years.

After proper installation, the angle is maintenance-free for its durability of 50 years. A special check of the angle is not required.

A compliant connection exists only with system-approved components (fittings and pipes that have been tested together). Using composite pipes other than those from Boni-Shop is at your own risk.

Yes, the pressfitting angle BONI-P62HAW16300 is multicontour-compatible. It can be fully pressed with TH- and U-press jaws, specifically for the dimension 16 x 2.0 mm.

For installation, you need a suitable pressing tool. The angle BONI-P62HAW16300 is Multikontur-compatible and can be processed with TH- or U-pressing jaws.

This elbow has been optimized for flow. The design with free passage ensures that there should be virtually no flow noise.

Yes, the angle is fully suitable for drinking water. It complies with DVGW DW-8501BS5049 and the UBA positive list, and it is low in lead or lead-free.

The pressfitting elbow is made of special brass with low lead content and is nickel-plated. It is fully suitable for drinking water and meets all requirements of the drinking water ordinance, even at common chlorine levels.

The pressfitting angle is not tight in the unpressed state. A pressure test should only be carried out after complete and proper pressing of all connections.